Attached the laser module to the now empty carriage, laser was already connected to the controler board. The plan was to connect the boards power in to the 12 V of the Anet Board. Encontre medcurso 2018 em segunda mo a partir de R 1. I had some 2pin connectors in my spare part box, so that was easy. Coleção de apostilas MedCurso 2018 + Apostilas Intensivão 2018 (Não inclui apostila do intensivão de GO). Coleo de apostilas MedCurso 2018 + Apostilas Intensivo 2018 (No inclui. Now there are two connectors left, a 2pin and a 3pin. I assume the 2pin is the PWM one that is to be connected to Fan1 on the anet board. Unfortunately both connectors on the laser board are labeled with PWM/TTL, so I am not sure if the 2pin connector can take the PWM signal, so just give it a try. When starting up the A8, the laser fires immediatly on full Power. It does not react to the Fan setting at all. Maybe I used the wrong fan Port? So switching to fan2 but getting same result. Pulling the cable completely so the 2pin ist connected at all, same result. #DESCARGAR APOSTILAS MEDCURSO 2018 FULL#.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |